How to Hack WiFi Using Android?

How to Hack WiFi Using Android?
Proceed only if your device falls under either of the
below category. Otherwise it is waste of time and
energy. For better results use Cyanogen ROM .
1. Android Device should be rooted.
2. Android Device should support bcmon App
(i.e s hould have Broadcom bcm4329/4330 wifi
chipset. [OR]
3. [Update] Now 'non bcmon supported devices' &
'devices which support external WiFi cards' can also
be used to hack WiFi. Check this post How To Hack
Wifi Using Android Without bcmon
Tools Used:
bcmon app [apk] -This tool enables Monitor Mode on
your rooted device with Broadcom chipset, which is
essential for hacking WiFi using android. Download
Reaver for Android or RfA - A WiFi pentesting tool
which can be used to attack WPS-enabled routers
and after the WPS-Pin is cracked, it can retrieves
the actual WPA-key. Download
Hacking WPA/WPA2 (WPS Enabled) WiFi
using Android [bcmon supported devices]
Download and install bcmon app .
Run bcmon. It may crash at first but keep trying. If
it still crashes after 3-4 attempts the device may not
be supported.
Install the firmware and tools,as prompted. Click on
' enable monitor mode '.
Download and install reaver and run it.
Reaver will scan for available access point.
Remember it can hack only WPS enabled WiFi.
Make sure Monitor Mode' is turned on. Make sure
that the "Automatic advanced settings" box is
checked.
Choose the network to hack and tap " Start Attack".
It will take between 2-10 hours to hack. And
sometimes it will never e successful depending on
the router type.
Hacking WEP type WiFi Using Android
Phone
Also Read :
WEP is an outdated,extremely weak  protocol to secure
WiFi and it is no more preferred because it can be
hacked within seconds. However due to lack of
awareness it is still used across the world. Below
instructions explain how you can use you android
device to hack a WEP protected WiFi network.
Procedure
bcmon app is used here also. So download and
install it as told above
Tap "Run bcmon terminal ". This will launch a
terminal similar to most Linux terminals.
Type airodump-ng and tap the Enter button. In the
newly opened window type airodump-ng wlan0 and
tap the Enter button.
Open reaver and note down the WiFi (Access point)
name,Mac Address and the broadcasting channel
of the WiFi which you want to hack. Make sure it is
WEP.
Now we can start scanning the target WiFi and
collect packets. Type the following
Note: channel# = broadcasting channel , MAC
address = Mac Address of the router which you
already noted down. -w is for specifying the output
file name. I have given outputfile in the
example. So the complete command look similar to
this.
Continue scanning untill it collects 20,000-30,000
packets.
Once enough packets are collected return to the
terminal and type aircrack-ng outputfile*.cap and
tap Enter. Aircrack program will attempt to crack
the WiFi password from the extracted packets.
It might take hours to crack. Finally a message Key
Found! will appear, followed by the key in
hexadecimal form. Key will work only if Probability"
is 100%.
Remove ":" from the key. i.e if it is 19:04:56:77:94 ,
the key would be 1904567794
There are many other methods to hack WiFi using
Android. Stay tuned for more tricks.
Credits: Bike Rider
Source shared on whatsapp by .. Rohit tiwari.. cise